Ellington E-WOD52ABZ5C, Installation Manual

3. Installation Preparation.

To prevent personal injury and damage, ensure 
that the hanging location allows the blades a 
clearance of 7ft. (2.13m) from the floor and 30in. 
(76cm) from any wall or obstruction. 
This fan is suitable for room sizes up to 400  
square feet (37.2 square meters).

This fan can be mounted with a 

downrod

on a normal or vaulted ceiling. The hanging 
length can be extended by purchasing a longer 
downrod (0.5in./1.27cm diameter). 

After installing 

hanging bracket, continue to Section 5 on page 4  
for those instructions. 

This fan can mount with 

flushmount

 installation 

only

 on a normal ceiling. 

After installing hanging bracket, continue to 
Section 6 on page 5 for those instructions.

Installation requires these tools:

Phillips screwdriver, flathead screwdriver, 
adjustable pliers or wrench, stepladder, wire 
cutters, and rated electrical tape.

4. Hanging Bracket Installation.

page 3

ON

OFF

ON

OFF

Vaulted ceiling 
angle is not to 
exceed 25 degrees.  

downrod

installation

flushmount

installation

12f

t.

 - 20f

t.

12ft. - 20ft.

(3.66m - 6.1m)

(3.66m - 6.1m)

blade edge

7 feet

(2.13m)

(76cm)

30 

inches

spring washers

flat washers

outlet box screws

hanging bracket

*Note

: It is very important that you use the proper hardware 

when installing the hanging bracket as this will support the fan. 

Turn off circuit breakers to current fixture from breaker 
panel and be sure operating light switch is turned to the 
OFF position. 

WARNING: 

Failure to disconnect power supply prior to 

installation may result in serious injury.

Remove existing fixture. 

WARNING:

 When using an existing outlet box, be sure the 

outlet box is securely attached to the building structure and 
can support the full weight of the fan. Ensure the outlet box is 
clearly marked "Suitable for Fan Support." If not, it must be 
replaced with an approved outlet box. Failure to do so can 
result in serious injury.

CAUTION

: 

Be sure outlet box is grounded properly and that 

a ground wire (green or bare) is present.

Install hanging bracket to outlet box using original 
screws, spring washers and flat washers provided with 
new or original outlet box.

*

 If installing on a vaulted 

ceiling, face opening of hanging bracket towards high 
point of ceiling. Arrange electrical wiring around the back 
of the hanging bracket and away from the bracket 
opening.