9. Blade Assembly.
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. (Be sure to install blades
with ridged-side facing up and flat side facing the
floor). Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with Phillips screwdriver. Repeat
procedure for remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat this
procedure with remaining blade arms. Securely
tighten all screws.
Note
: Tighten blade arm screws twice a year.
page 7
blade arm
screws
lock washers
blade attachment
screws and washers
motor housing
blade arm
blade
If you wish to use fan WITHOUT the light kit
,
please proceed to Section 11 on page 8 to complete
installation.
If you wish to use fan WITH the light kit:
Remove 3 screws from switch housing cap and
remove switch housing cap from switch housing.
Punch center cap out of switch housing cap with a
screwdriver.
IMPORTANT:
Any light kit purchased for use with this
fan
MUST be UL-APPROVED for WET LOCATIONS or
OUTDOOR USE.
Locate
BLUE
(or
BLACK
) and
WHITE
wires in switch
housing labeled FOR LIGHT KIT CONNECTION.
Remove and discard plastic that holds these 2 wires
together.
Locate hex nut and lock washer in hardware pack.
Push wires from light kit fitter through center hole
in switch housing cap and then screw switch
housing cap onto threaded rod.
["Light Kit Assembly" continued on next page.]
10. Light Kit Assembly (Optional).
switch housing cap
hex nut
lock washer
light kit fitter
motor housing
switch housing
switch
housing
cap
blue (or black) wire
white wire
center cap
plastic
motor
lock
Summary of Contents for E-WOD52ABZ5C
Page 9: ......
