page 4
5. Fan Assembly (with downrod).
yoke set screw
and nut
downrod
electrical wiring
pin
clip
canopy
motor housing
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4in. downrod provided to use with an
extended downrod (sold separately). [
If you
wish to use the 4in. downrod, please proceed to
instructions following the dotted line below.
]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Slide downrod through canopy.
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Tip
: Apply small piece of electrical tape to the
ends of the electrical wires to keep them
together when threading them through the
downrod.
Loosen yoke set screws and nuts and remove
pin and clip from motor housing yoke. Place
downrod into the motor housing yoke and
re-insert pin and clip. Tighten yoke set screws
and nuts securely.
set screw hole
set screw
hanging ball
stop pin
A
B
NOTE
: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
["Fan Assembly" continued on next page.]
