page 7
7. Canopy Assembly.
8. Blade Assembly.
canopy
hanging bracket
Time Saver:
Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. [
Be sure to note label
on blade indicating
THIS SIDE UP
and turn
blade so that label faces ceiling.] Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (
save blade arm screws and
lock washers to secure blade arms
). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat procedure with remaining blade arms.
Securely tighten all screws.
Note
: Tighten blade arm screws twice a year.
blade arm
blade
blade attachment
screws and washers
lock
washers
blade arm screws
motor housing
plastic
motor
lock
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed, and then
tighten both screws securely. Slide canopy cover
up to canopy, press up gently but firmly on
canopy cover until you hear it snap onto the
bottom of the canopy.
screw
screw
canopy
cover
