background image

page 6

7. Canopy Assembly.

screw

canopy

hanging bracket

screw

Locate 2 screws on underside of hanging bracket and 
remove screw closest to the open end of the hanging 
bracket. Partially loosen the other screw. Lift canopy to 
hanging bracket. Place rounded part of slotted hole in 
canopy over loosened screw in hanging bracket and 
push up. Twist canopy to lock. Re-insert screw that was 
removed and then tighten both screws securely. Slide 
canopy cover up to canopy, aligning rounded part of 
slotted holes in canopy cover with screwheads in 
bottom of canopy. Turn canopy cover to the right 
(clockwise) until it stops.

canopy cover

6. Wiring.

CAUTION

Be sure outlet box is properly grounded 

and that a ground wire (

GREEN

 or Bare) is present.

Make sure all electrical connections comply with 
Local Codes or Ordinances and the National Electrical 
Code. If you are unfamiliar with electrical wiring or if 
the house/building wires are different colors than 
those referred to below, please use a qualified 
electrician.

Note: 

Excess lead wire length from the fan can be cut 

to the desired length and then stripped.

When downrod is secured in place on the hanging 
bracket, electrical wiring can be made as follows:
Connect 

BLACK

 wire from fan to 

BLACK

 wire from 

ceiling with wire connector provided.
Connect 

WHITE

 wire from fan to 

WHITE

 wire from 

ceiling with wire connector provided.
Connect all 

GROUND 

(

GREEN

) wires together from 

fan to 

BARE

/

GREEN

 wire from ceiling with wire 

connector provided.

Since this fan does not come with a light kit, you 
will need to cap off the 

BLUE 

wire with a wire 

connector (as shown with arrow in diagram). 
[

Note

: If you elect to purchase a light kit for the fan, 

the 

BLUE

 wire from the fan must be connected to 

the 

BLACK

 wire from the ceiling instead.]

* Wrap each wire connector separately with 
electrical tape as an extra safety measure.

wire

connector

This fan is remote control adaptable (remote 
control sold separately). 

black

black

white

white

blue

black supply wire

ground

 (green

or bare)

white supply wire

from ceiling

from fan

ground 
(green or bare)

*

Summary of Contents for SUA56BNK5











Reviews: