9 of 15
the heater will automatically
switch to 100% power.
Off
To switch the heater off:
Press OFF. The heater will switch
to standby mode(the receiver
indicator will light up).
Notice
：
Use 2 pieces AAA size 1.5V batteries in the remote control. Remove the battery when not use
for long time, thus the lifespan of remote control can be extended.
Choose the same specification battery when replacing the battery inside, otherwise it may
cause remote control not work , thereby affect the normal use of the heater.
Please contact service agent for further help if you need the function.
The remote control function may be out of work if there is a barrier between the remote
control and heater .
Replacing the batteries duly so as not to affect the normal use of heater and remote control.
Operation Instruction
Install the heater according to the following steps.
1,Open the outer carton,remove all the packing
materials(including heating lamp shaking protection
packing ),then check if everything is OK for the heating
mould,heater stand mould,wire cable and plug.
2,Take out of the heating mould,heater stand mould,heater
stand base,screws and assembling tools.
3,Connect the two curved poles.see Fig.1.then put 3pcs
M6X8 in the corresponding holes,tight them by tools.Please
pay attention that Do not damage the wire cable during the
