Elma 6100EVSE
18
Safety
1.1 International Safety Symbols
This symbol, adjacent to another symbol or terminal, indicates the user must refer to the
manual for further information.
This symbol, adjacent to a terminal, indicates that, under normal use, hazardous voltages
may be present
Double insulation
SAFETY NOTES
•
Do not exceed the maximum allowable input range of any function.
•
Do not apply voltage to meter when resistance function is selected.
•
Set the function switch
OFF
when the meter is not in use
•
Remove the battery if meter is to be stored for longer than 60 days.
WARNINGS
•
Do not apply voltage to meter when resistance function is selected.
•
When measuring volts do not switch to current/resistance modes
•
Do not measure current on a circuit whose voltage exceeds 600V
•
When changing ranges always disconnect the test leads from the circuit under test.
•
Do not exceed the maximum allowable input range of any function.
CAUTIONS
•
Improper use of this meter can cause damage, shock, injury or death. Read and understand
this user manual before operating the meter.
•
Always remove the test leads before replacing the battery or fuses.
•
Inspect the condition of the test leads and the meter itself for any damage before operating
the meter. Repair or replace any damage before use.
•
Use great care when making measurements if the voltages are greater than 25VAC rms or
35VDC. These voltages are considered a shock hazard.
•
Always discharge capacitors and remove power from the device under test before
performing Diode, Resistance or Continuity tests.
•
Voltage checks on electrical outlets can be difficult and misleading because of the
uncertainty of connection to the recessed electrical contacts. Other means should be used
to ensure that the terminals are not "live".
•
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Function
Maximum input
A AC, A DC
10A AC/DC
V AC, V DC, Frequency, Duty Cycle, EVSE-CP
600 V AC/DC
Resistance, Capacitance, Diode Test, Flexible AC Current
250 V AC/DC
Summary of Contents for 6100EVSE
Page 24: ...Hlo V 211208 08 19 55...