Care and maintenance tasks
© Elma Schmidbauer GmbH
BA_Elmasolvex_VA_EN_Vers.05.2018
75
9.2.3
Basket holder
Particularly when using third party baskets, there is an
increased risk of wear of the bottom support surfaces.
When changing the media
The support surfaces at the bottom of the basket holder must
be flat (
Fig. 9.2.3.1.A
). In the case of wear (
Fig. 9.2.3.2.B
), the
basket holder must be replaced.
If the specified surfaces are worn, there is the risk that the
baskets are no longer correctly fixed in the basket holder. The
consequence of this is that cleaning parts can be flung out of
the baskets.
Fig. 9.2.3.1 Intact support surfaces
Fig. 9.2.3.2 Worn support surfaces
Check the toothing of the collar bushing (
Fig. 9.2.3.3
.C) for
wear. The collar bushing must be replaces as soon as any wear
on the toothing is recognisable (
Fig. 9.2.3.5.E
). Worn toothing
of the collar bushing results in unbalance of the cleaning basket
at higher speeds.
Fig. 9.2.3.3 Basket holder underside / position of the collar bushing
Recommended interval
Basket holder
inspection criteria
ATTENTION
Collar bushing
inspection criteria
A
B
C
