Putting into operation
© Elma GmbH & Co KG
BA/ Transsonic TI-H_GB_0306
15
6
Putting into operation
6.1
Filling of the unit with cleaning liquid
Caution!
For reasons of safety pull the mains plug when filling
the unit with cleaning liquid.
Shut the drain duct before filling the tank.
Fill the cleaning tank with a sufficient quantity of a suitable
cleaning liquid before switch-on.
TI-H 5 – TI H 20: Use the filling level marking inside the tank to
find the correct filling level.
TI-H 25 – TI H 160: The level switch must be covered with
liquid.
The optimum filling level is indicated by the upper edge of the
overflow.
If the cleaning liquid goes below a certain level the unit is
automatically switched off by the level switch. This prevents the
unit from running dry which might cause damage to the
material.
Use aqueous cleaning liquids only: ensure that the chosen
cleaning chemical is suitable for treatment in an ultrasonic bath
and observe the instructions on dosage and the compatibility of
the material
.
All flammable cleaning media with a flash point lower than
indicated on page 1 of these Operating Instructions (see flash
point) must not be used in an ultrasonic bath. Observe the
safety warnings in section 8 (Cleaning liquids).
Pull the mains plug
Shut the drain
Observe filling level
Allowed cleaning
media
Prohibited cleaning
media
Risk of fire and explosion!
Never use flammable liquids, or solvents, directly in an
ultrasonic cleaning bath.
CAUTION
Ultrasonic activity increases the vapourization of liquids and
creates a very fine mist which can catch fire on any ignition
source.
Observe the instructions on limitations of use given in section
8.1.
