- 15 -
7.10. Definition of monitoring station subscriber account number .
Service Settings
→ GSM monitoring → Subscriber account number
This menu is used to define subscriber code (max. 8 characters) used by monitoring station
operating in e.g. “Ademco Contact ID” to identify SMS notification sender (see pt. 7.11.7).
7.11. Auxiliary GSM notification settings.
Service Settings
→ GSM monitoring → Aux GSM settings
1) Test as CLIP <-> Test as SMS
- interval test as CLIP call or SMS;
2) Execute test at time <-> Execute test after interval - test executed daily at predefined test
time, or test after predefined time interval;
3) SMS with password - if Y (yes), SMS send to CB32G must begin with password;
4) Letter case sensitive - N (no) as standard. If selected Y (yes), the control panel is SMS let-
ters case sensitive;
5) Alarm CLIP once - if this function is set off (N), control panel expects CLIP notification re-
jection. If the call (see pt. 7.4) is not rejected, the panel disconnects and repeats CLIP call
twice. If the function is set on (Y), CLIP calling is made once only, even the call was not r e-
jected. It does not refer to a control CLIP that is made only once;
6) Use default SMS centre no <-> Use entered SMS centre no
– selection of the first option
allows CB32G panel to use SMS centre number supplied with SIM card, while selection of
the second option causes CB32G to use centre number entered in 7.1.
7) Ademco Contact ID
→ Subs event code → Subs event code + zone no
The settings is valid only,
if “SMS with ID codes” is set on in pt. 5.6.8 and allows selection
of one of three SMS notification patterns send to monitoring station:
1) ”Ademco Contact ID” pattern. SMS notification has the following form:
CCCCQEEEGGZZZ
where
“CCCC” stands for subscriber code set in pt. 7.10. Other elements are defined by
the user, e.g. three digits event number “EEE”. NOTE: if monitoring station requires digits
“18” to appear before “CCCC” then subscriber’s code should input as “18CCCC” in
pt.7.10.
2) ”Subs event code” pattern. SMS notification has the following form:
CCCCEE
where CCCC stands for subscriber code set in pt. 7.10 and
“EE” event code set in pt.7.9.
3) ”Subs event code + zone no” pattern. SMS notification has the following form:
CCCCEEZZ
where CCCC is sub
scriber, “EE” event code and
end
“ZZ”
is zone or user number
.
8. Auxiliary functions settings.
This menu contains auxiliary functions and options for alarm system configuration available in
the CB32G control panel.
Use ▲▼ to toggle between functions and ◄► buttons to change
setting. OK button saves selection. Exit menu any time with C button without saving selection.
8.1 Radio jamming protection.
Service Settings
→ Aux functions → Jamming protection
This function allows radio jamming anti-sabotage protection of wireless alarm system. If se-
lected (Y), it will activate sabotage alarm in zone 30 on all deliberate or incidental jamming in
used radio band.
8.2 Radio link test.
Service Settings
→ Aux functions → Radio link test
Setting this function to (Y) enables monitoring of the detector presence. Radio link transmis-
sions are sent at cyclic intervals from detectors (except for CTX3H) received by CB32G con-
