28
Connecting to RGB IN terminal
1. Connect the projector to a device such as a computer using RGB
cable.
Connect the RGB output terminal (MiniD-sub 15p) of your device such as a
computer to the RGB IN terminal of the projector using an RGB cable (sold
separately) as shown in the below picture.
After firmly inserting the cable into the connector, tighten the screws on the
connector.
BACK
■
The aspect ratio of the projected image may not be correct depending
on the video format that is input to the RGB IN terminal.
In such cases, change the setting from the display setting menu or
change the resolution of the device connected to the projector.
■
If no image is displayed on the screen when connecting a notebook
computer, set the computer so that it can output RGB signals externally.
The setting procedure varies depending on the type of the computer.
Refer to the instruction manual of your computer.
- Operation of notebook computer
Either is pushed Fn
＋
F1
～
F12 (*Depending on the model.)
■
No sound will be output from the built-in speaker when a device is
connected to the RGB IN terminal. If you want sound, use a speaker
with amplifier.
RGB cable
(Sold separately)
Device (such as a computer)
N o t e
