- 20 -
(1) Setting an ID No.
• Turn ON only the camera to be set with an ID
No. Turn OFF the other adjacent Cameras.
(Unplug from the outlet.)
• Set the remote ID No. to the Camera. (See "6.
OSD (On-Screen Display) on P.22) After
setting, close the Menu screen by pressing
MENU
button. Then, repeat the ID No.
setting for all other Cameras in the same way.
(2) Operating the Cameras selectively
• Press
ID
button, and the LED's of all
adjacent Cameras will start blinking (at
intervals of 0.4 sec). To cancel this, press
ID
button again. Then, press
1
through
9
buttons, and the LED's will go out, and
selective operation by specifying the ID No.
will be ready. Now, only the selected Camera
can be operated via the wireless remote
controller.
4
3
3
17
(3) Canceling the specific ID of the Cameras
• Hold down
ID
button for over 2 sec, and the blinking LED on the Camera will
light up. Then, unhand
ID
button. Now, the selective operation has been
cancelled, and all adjacent Cameras start operation via the wireless remote controller.
• Even if the Camera is rebooted, the selective operation by specifying the ID No. is
cancelled.
3
3
When multiple Cameras are laid out adjacently and operated via the wireless remote
controller, the Cameras receiving the infrared rays operates in unison in the same way.
When each Camera is allocated with a different ID No., the Camera can be operated
selectively when its ID No. is specified via the wireless remote controller. The ID Nos. can
be allocated to up to 9 Cameras.
3
17
4
5. THE ID NUMBER (REMOTE ID) SETTING
