- 82 -
(14) IP filtering Setup
Make settings relating to the IP filter.
Note
: Making the settings described here may prevent connection to the
Camera. Perform the setting operation with extreme care.
• Enable IP Filtering................ Select whether to use the IP filter function.
• Accept All............................. Accepts any client connected to the Camera, except
connections from the IP addresses shown in Exception
List. (Only connections from the IP addresses contained in
the client list will be rejected.)
• Reject All ..............................Rejects all clients attempting to connect to the Camera. It
can be connected from the IP addresses shown in
Exception List. (Only connections from the IP addresses in
Exception List will be permitted.)
• Modifying an address
Select the address you want to modify from the list.
Change the address set at each of “Start IP” and “End IP,” and click on the [Modify]
button.
• Deleting an address
Select the address you want to delete from the list, and click on the [Remove] button.
• Reset
The button sets all addresses registered in the list at “0.0.0.0.”
