- 90 -
[5] Set items
Name
Function
Factory settings
ID
The following three items can be set according to the
root
user settings:
(Admini-
Administrator
: The login ID for the administrator. The strator)
login ID is “root” that is unchangeable. With this login ID,
you can view images, operate the Camera, and make
settings.
Operator
: You can view images and operate the
Camera.
User
: You can only view images.
* Only “root” can be registered for Administrator, and
up to 99 names can be registered for Operator and
User combined.
* You can use up to 16 one-byte characters for a name,
including alphanumerical characters and upper-case
and lower-case alphabetic characters.
Password
Set a password for the ID.
root
* You can use up to 16 one-byte characters for a
password, including alphanumerical characters and
upper-case and lower-case alphabetic characters.
●
ELMO 1Channel Viewer ID, password
Name
Function
Factory settings
ID
Set an ID.
(none)
Set it at the initial use of ELMO 1Channel Viewer after
it was installed. Once it is registered, you cannot
change it.
Password
Set a password for the ID.
(none)
Set it at the initial use of ELMO 1Channel Viewer after
it was installed. Once it is registered, you cannot
change it.
●
External GPIO
Name
Function
Factory settings
Activation
Set the output mode.
Normal
Mode
Normal Open
: High impedance is usually activated,
Open
and the GND level becomes valid during output.
Normal Close
: The GND level is usually activated,
and high impedance becomes valid during output.
●
Camera ID, password
