19
日
本
語
Eng
lis
h
F
ranç
ai
s
Deu
ts
ch
Es
paño
l
ة
يب
رع
لا
BEFORE YOU USE
■
The supplied power cord and AC adapter are designed for exclusive use with this
product. Do not use them with other products.
■
Be sure to use the power cord applicable to your local power specifications. If the
product was sold in Japan, use the AC adapter sold with the product with 100 VAC
and 50 or 60 Hz.
■
When storing the product, do not leave it under direct sunlight or by heaters. It
may be discolored, deformed, or damaged.
■
Do not place this product in any humid, dusty, salt bearing wind, or vibrating
locations.
Use it under the following environmental conditions:
Temperature：0℃～ 40℃ Humidity：30％～ 85％(No condensation)
■
Do not put your finger between the arms when moving the arm. You may pinch
your finger and result in injury.
It is recommended to attach the supplied caution sticker to the product.
■
Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
■
Do not point the lens directly to the sun. It could degrade the imaging capability.
■
Luminescent and Black Spots
There may be some pixels that do not properly operate due to the use of CMOS
Area Image Sensors made-up of many pixels.
Though luminescent or black spots may be found on the screen, it is a
phenomenon peculiar to the CMOS Area Image Sensors and is not a malfunction.
■
A protection sheet is attached to the touchscreen at the factory to avoid damage
during transportation. Remove the sheet before use.
Do not strongly press the touchscreen or press it with sharp objects. This may
result in damage or malfunction to the touchscreen.
■
Follow the guidelines below to prevent the unit from dropping or overturning.
・ Use the product on a stable base, desk, or table. Do not place the product on an
unstable base or slanted location.
・ Place or wire the product so as to prevent the cables from being pulled or
drawn.
■
Never hold the product by the arm or the camera head. Carry the product by
holding the lower part of the main unit in both hands after folding the arm and the
camera head.
■
Pay careful attention when using (including setting-up and storing) or carrying the
product to prevent the camera head from receiving any shocks.
■
After folding the product, do not place heavy object on the arm.
■
Do not look directly into the LED light. If you look directly into it at pointblank
range, your eyes may be injured.
■
The LED may get hot after using it for long hours. Do not touch it directly.
It is recommended to attach the supplied caution sticker to the product.
■
Depending on the type of the SD card or USB flash drive, it may not be used with
the product.
■
Transfer the data from the SD card or USB flash drive onto a device such as a PC
to save a backup copy.Malfunction of the product or repairs to it may cause the
data saved in the SD card or USB flash drive to be deleted.
■
If this product is used for longer than the warranty period, its performance and
quality may deteriorate due to the lifetime of its parts. For parts replacement (on
chargeable basis), consult the dealer from whom you purchased this product or
our branch/office near your location.
■
Battery precautions:
・ Remove the battery from the remote control when not in use for an extended
period of time.
Summary of Contents for PX-10E
Page 72: ......
