13
ADJUSTING NEEDLE BAR HEIGHT
ADJUSTING NEEDLE BAR HEIGHT
ADJUSTING NEEDLE BAR HEIGHT
ADJUSTING NEEDLE BAR HEIGHT
ADJUSTING NEEDLE BAR HEIGHT
THE STANDARD DISTANCE BETWEEN THE UPPER EDGE OF THE NEEDLE EYE AND
THE TIP OF THE ROTARY HOOK SHOULD BE IN THE RANGE OF 1.6 TO 2.0 MM WHEN
THE ROTARY HOOK MEETS THE RIGHT SIDE OF THE NEEDLE IN ASCENDING TRAVEL
OF NEEDLE FROM ITS LOWEST POSITION.
NOTE:
ENSURE THAT THE NEEDLE TO HOOK TIMING IS CORRECTLY ADJUSTED BEFORE ADJUSTING
THE NEEDLE BAR HEIGHT.
1. TURN ON THE POWER SWITCH AND SELECT THE STITCH PATTERN " " ADJUST THE NEEDLE
DROP POSITION TO 0.0 (LEFT MOST POSITION), THEN TURN OFF THE POWER SWITCH.
2. REMOVE THE NEEDLE PLATE AND BOBBIN HOLDER.
3. ALIGN THE TIP OF ROTARY HOOK WITH THE RIGHT SIDE OF THE NEEDLE IN ASCENDING TRAVEL
OF NEEDLE FROM ITS LOWEST POSITION BY TURNING THE HANDWHEEL TOWARD YOU.
4. REMOVE THE FACE PLATE AND LOOSEN THE SETSCREW.
5. MOVE THE NEEDLE BAR UP AND DOWN TO ADJUST THE NEEDLE BAR HEIGHT.
6. MAKE SURE THAT THE NEEDLE BAR GROOVE IS IN FRONT OF YOU AND TIGHTEN THE SCREW.
7. ATTACH THE BOBBIN HOLDER, NEEDLE PLATE AND FACE PLATE.
SCREW
NEEDLE BAR GROOVE
TOP OF NEEDLE EYE
1.8
±
0.2mm
ROTARY HOOK RACE
NEEDLE #14
MATCHING POINT
SURFACE OF HOOK RACE
NEEDLE PLATE
BOBBIN HOLDER
Summary of Contents for 6200 -
Page 1: ......
