15
Ａ
Ｂ
ADJUSTING BACKLASH BETWEEN HOOK DRIVE GEAR AND
ADJUSTING BACKLASH BETWEEN HOOK DRIVE GEAR AND
ADJUSTING BACKLASH BETWEEN HOOK DRIVE GEAR AND
ADJUSTING BACKLASH BETWEEN HOOK DRIVE GEAR AND
ADJUSTING BACKLASH BETWEEN HOOK DRIVE GEAR AND
LOWER SHAFT GEAR
LOWER SHAFT GEAR
LOWER SHAFT GEAR
LOWER SHAFT GEAR
LOWER SHAFT GEAR
ROTARY PLAY OF GEARS SHOULD BE 0.8 MM OR LESS WHEN THE TIP OF THE
ROTARY PLAY OF GEARS SHOULD BE 0.8 MM OR LESS WHEN THE TIP OF THE
ROTARY PLAY OF GEARS SHOULD BE 0.8 MM OR LESS WHEN THE TIP OF THE
ROTARY PLAY OF GEARS SHOULD BE 0.8 MM OR LESS WHEN THE TIP OF THE
ROTARY PLAY OF GEARS SHOULD BE 0.8 MM OR LESS WHEN THE TIP OF THE
ROTARY HOOK IS WITHIN THE WIDTH OF THE FEED DOG AS SHOWN BELOW.
ROTARY HOOK IS WITHIN THE WIDTH OF THE FEED DOG AS SHOWN BELOW.
ROTARY HOOK IS WITHIN THE WIDTH OF THE FEED DOG AS SHOWN BELOW.
ROTARY HOOK IS WITHIN THE WIDTH OF THE FEED DOG AS SHOWN BELOW.
ROTARY HOOK IS WITHIN THE WIDTH OF THE FEED DOG AS SHOWN BELOW.
TO CHECK
TO CHECK
TO CHECK
TO CHECK
TO CHECK
1.
TURN THE POWER SWITCH OFF. REMOVE THE NEEDLE PLATE AND BOBBIN HOLDER.
REMOVE THE BED COVER.
2.
TURN THE HANDWHEEL SLOWLY TOWARD YOU UNTIL THE TIP OF THE HOOK (A) IS BETWEEN
WIDTH (B) OF FEED DOG.
3.
SWAY THE HOOK RACE WITH FINGERS. CHECK THE PLAY. IT SHOULD BE 0.8 MM OR LESS.
* IF THERE IS MORE THAN 0.8 MM PLAY, ADJUST AS FOLLOWS.
ADJUSTMENT PROCEDURE:
ADJUSTMENT PROCEDURE:
ADJUSTMENT PROCEDURE:
ADJUSTMENT PROCEDURE:
ADJUSTMENT PROCEDURE:
1.
REMOVE THE BED COVER AND LOOSEN THE HEXAGONAL SCREW (C).
2.
TURN THE LOWER SHAFT BUSHING (D) (ECCENTRIC), IN THE DIRECTION "E" WHEN THE PLAY
AT HOOK TIP IS TOO SMALL.
3.
TURN THE LOWER SHAFT BUSHING (D) (ECCENTRIC), INT THE DIRECTION "F" WHEN THE PLAY
AT THE HOOK TIP IS TOO LARGE.
4.
TIGHTEN HEXAGONAL SCREW (C) SECURELY AFTER ADJUSTMENT.
LOWER SHAFT BUSHING
HEXAGONAL SCREW (C)
LOWER SHAFT GEAR
GROOVE OF LOWER SHAFT BUSHING (D)
(B)
TIP OF THE HOOK
ROTARY PLAY
SHOULD BE 0.8
MM OR LESS
Summary of Contents for 6200 -
Page 1: ......
