16
0.85±0.05mm
WHEN THE PRESSER FOOT IS LOWERED WITH THE PRESSURE DIAL SET AT
WHEN THE PRESSER FOOT IS LOWERED WITH THE PRESSURE DIAL SET AT
WHEN THE PRESSER FOOT IS LOWERED WITH THE PRESSURE DIAL SET AT
WHEN THE PRESSER FOOT IS LOWERED WITH THE PRESSURE DIAL SET AT
WHEN THE PRESSER FOOT IS LOWERED WITH THE PRESSURE DIAL SET AT
"3", THE HIGHEST POSITION OF THE FEED DOG SHOULD BE 0.8 TO 0.9 MM
"3", THE HIGHEST POSITION OF THE FEED DOG SHOULD BE 0.8 TO 0.9 MM
"3", THE HIGHEST POSITION OF THE FEED DOG SHOULD BE 0.8 TO 0.9 MM
"3", THE HIGHEST POSITION OF THE FEED DOG SHOULD BE 0.8 TO 0.9 MM
"3", THE HIGHEST POSITION OF THE FEED DOG SHOULD BE 0.8 TO 0.9 MM
ABOVE THE SURFACE OF THE NEEDLE PLATE.
ABOVE THE SURFACE OF THE NEEDLE PLATE.
ABOVE THE SURFACE OF THE NEEDLE PLATE.
ABOVE THE SURFACE OF THE NEEDLE PLATE.
ABOVE THE SURFACE OF THE NEEDLE PLATE.
1.
SET THE PRESSURE DIAL AT "3" AND LOWER THE PRESSURE FOOT THEN TURN ON THE POWER
SWITCH.
2.
TURN THE HANDWHEEL TOWARD YOU UNTIL THE FEED DOG COMES TO ITS HIGHEST POSITION.
3.
REMOVE THE BED COVER (SEE PAGE 7)
4.
LOOSEN SET SCREW (A) AND NUT.
5.
TURN THE ADJUSTING SCREW (C) IN THE DIRECTION OF "E" TO RAISE THE FEED OR TURN THE
ADJUSTING SCREW (C) IN THE DIRECTION OF "D" TO LOWER THE FEED DOG, SO THAT THE FEED
DOG HIGHEST IS FROM 0.85 MM ABOVE THE TOP SURFACE OF THE NEEDLE PLATE.
6.
TIGHTEN THE NUT AND SET SCREW(A).
7.
ATTACH THE BED COVER.
FEED DOG HEIGHT ADJUSTMENT
FEED DOG HEIGHT ADJUSTMENT
FEED DOG HEIGHT ADJUSTMENT
FEED DOG HEIGHT ADJUSTMENT
FEED DOG HEIGHT ADJUSTMENT
PRESSURE DIAL AT 3
STANDARD FOOT
SURFACE OF THE
NEEDLE PLATE
FEED DOG
E (TO RAISE)
D
(TO LOWER)
ADUSTING SCREW (C)
NUT(B)
SETSCREW (A)
Summary of Contents for 6200 -
Page 1: ......
