ELNA 6200 -, Service Manual

18

A

B

WHEN THE POLYESTER SEWING THREAD #50 (WHITE) IS PASSED THROUGH

WHEN THE POLYESTER SEWING THREAD #50 (WHITE) IS PASSED THROUGH

WHEN THE POLYESTER SEWING THREAD #50 (WHITE) IS PASSED THROUGH

WHEN THE POLYESTER SEWING THREAD #50 (WHITE) IS PASSED THROUGH

WHEN THE POLYESTER SEWING THREAD #50 (WHITE) IS PASSED THROUGH
AND PULLEAD UP AS IN FIG. 1, THE THREAD TENSION SHOULD BE 75 TO

AND PULLEAD UP AS IN FIG. 1, THE THREAD TENSION SHOULD BE 75 TO

AND PULLEAD UP AS IN FIG. 1, THE THREAD TENSION SHOULD BE 75 TO

AND PULLEAD UP AS IN FIG. 1, THE THREAD TENSION SHOULD BE 75 TO

AND PULLEAD UP AS IN FIG. 1, THE THREAD TENSION SHOULD BE 75 TO
90 GRAMS (THE THREAD PULLING SPEED: APROX. 110 MM/SEC) WITH THE

90 GRAMS (THE THREAD PULLING SPEED: APROX. 110 MM/SEC) WITH THE

90 GRAMS (THE THREAD PULLING SPEED: APROX. 110 MM/SEC) WITH THE

90 GRAMS (THE THREAD PULLING SPEED: APROX. 110 MM/SEC) WITH THE

90 GRAMS (THE THREAD PULLING SPEED: APROX. 110 MM/SEC) WITH THE
THREAD TENSION DIAL SET AT "AUTO). IF THE TENSION IS OUT OF THE

THREAD TENSION DIAL SET AT "AUTO). IF THE TENSION IS OUT OF THE

THREAD TENSION DIAL SET AT "AUTO). IF THE TENSION IS OUT OF THE

THREAD TENSION DIAL SET AT "AUTO). IF THE TENSION IS OUT OF THE

THREAD TENSION DIAL SET AT "AUTO). IF THE TENSION IS OUT OF THE
STANDARD RANGE, ADJUST IT AS FOLLOWS.

STANDARD RANGE, ADJUST IT AS FOLLOWS.

STANDARD RANGE, ADJUST IT AS FOLLOWS.

STANDARD RANGE, ADJUST IT AS FOLLOWS.

STANDARD RANGE, ADJUST IT AS FOLLOWS.

NEEDLE THREAD TENSION

NEEDLE THREAD TENSION

NEEDLE THREAD TENSION

NEEDLE THREAD TENSION

NEEDLE THREAD TENSION

ADJUSTMENT PROLEDURE:

ADJUSTMENT PROLEDURE:

ADJUSTMENT PROLEDURE:

ADJUSTMENT PROLEDURE:

ADJUSTMENT PROLEDURE:
1.

SET THE THREAD TENSION DIAL AT "AUTO".

2.

REMOVE THE FACE COVER (SEE PAGE 9).

3.

TURN THE LEAD SCREW TO ADJUST THE NEEDLE THREAD TENSION.
IF THE THREAD TENSION IS TOO TIGHT, TURN THE LEAD SCREW IN THE DIRECTION OF "A".
IF THE THREAD TENSION IS TOO LOOSE, TURN THE LEAD SCREW IN THE DIRECTION OF "B".

4.

CHECK THE THREAD TENSION AGAIN AND REATTACH THE FACE COVER.

NEEDLE  THREAD:  POLYESTER
SEWING THREAD # 50 (WHITE).

PULL THE THREAD AT A SPEED OF 110 MM/SEC, IN
THE DIRECTION OF THE ARROW.

LEAD SCREW