34
ADJUSTING BUTTONHOLE LEVER POSITION
ADJUSTING BUTTONHOLE LEVER POSITION
ADJUSTING BUTTONHOLE LEVER POSITION
ADJUSTING BUTTONHOLE LEVER POSITION
ADJUSTING BUTTONHOLE LEVER POSITION
TO ADJUST THE BUTTONHOLE LEVER GUIDE:
1. SET THE MACHINE IN BUTTONHOLE SENSOR ADJUSTING MODE.
(SEE BELOW. THE SCREEN SHOULD DISPLAY "H" OR "L".)
2. REMOVE THE FACE COVER AND LOOSEN SETSCREW(A).
3. LOWER THE BUTTONHOLE LEVER. POSITION THE BUTTONHOLE LEVER GUIDE SO THE SCREEN
DISPLAYS "L". TIGHTEN SETSCREW (A).
TO ADJUST THE BUTTONHOLE SENSOR POSITION:
4. INSTALL THE BUTTONHOLE FOOT (R).
5. LOWER THE BUTTONHOLE LEVER TO ITS LOWEST POSITION, AND INSERT A 1.6 MM THICKNESS
GAUGE.
6. TURN THE ADJUSTING SCREW TO THE LEFT UNTIL THE SCREEN DISPLAY CHANGES FROM "L"
TO "H".
7. THEN, TURN THE ADJUSTING SCREW TO THE RIGHT UNTIL THE SCREEN DISPLAY CHANGES
FROM "H" TO "L".
8. CHECK IF THE LED SCREEN SHOWS "H" WHEN THE CLEARENCE OF THE BUTTONHOLE FOOT IS
1.4 MM AND "L" WHEN THE CLEARENCE IS 1.8 MM.
9. TURN OFF THE POWER SWITCH.
10.INSTALL THE FACE COVER.
NOTE
IF THERE IS ANY LINT IN THE BUTTONHOLE SENSOR SLIT, CLEAN OUT WITH A SWAB.
TO ENTER ADJUSTING MODE
BUTTONHOLE LEVER GUIDE
SETSCREW (A)
BH LEVER
ADJUSTING SCREW
BUTTONHOLE SENSOR
CLEARANCE
1.6 MM
SETSCREW (B)
SETSCREW (B)
2. PRESS THE "+" OF STITCH
LENGTH BUTTON TO SELECT
"2".
3. PRESS THE "–" OF STITCH
LENGTH BUTTON.
1. TURN THE POWER ON WHILE
PRESSING THE "–" OF ZIGZAG
WIDTH BUTTON AND "+" OF STITCH
LENGTH BUTTON.
Summary of Contents for 6200 -
Page 1: ......
