ELNEC s.r.o.
3.
When the built-in computer is turned on the
operating system
will start booting-
4.
operating system can take some time normally this time is shorter
wMC
control
on on “
Welcome
” screen to continue. The main screen with
t.
tand-Alone multiprogramming system, or when error
message “
Programmer Sites not found
” is displayed, then programmer
reinitialized by action “
Search for Programmers
...” available in
mer / Search for Programmers...
”.
program
age will be
ds
or more and start
“No Programmers found”, please
S
er sites
hidden
control application
Pg4uw
.
menu
main screen.
numbered from #1 to #8 in direction of physical placement
ection is “
Ready
” or “
No project file is loaded
“ user
le from menu
File / Load project
.
Selec
16. Use menu “Device / Predefined operation“ to select device Master operation.
Following Master operations are available:
up, cooling fans should start to work, and “
Wait please
” screen should be
displayed on graphical control unit.
Starting of the
than 1 minute.
5. After the operating system has successfully started, the
Pg4u
program will start
automatically
. When the Pg4uwMC is ready to work the
“
Welcome
” screen is displayed on graphical control unit.
6. Click
the
OK
butt
menus and
Status
panel should appear on graphical control uni
Checking if the sites are ready to be connected
7. When
first starting
S
software must be
menu “
Program
8. In dialog Search for Programmers use button “
Search
” to search for present
programmer sites. The result of search will be displayed in table Search results in
Search dialog. When programmer sites are successfully found, then programmer
type and its serial number is show in the table Search result. Detected
mer can be accepted by pressing/touching
Accept
. If no complete
programmer was found, then “
No Programmers found
” mess
displayed in table Search results and button Accept will be disabled.
9.
If search result is “
No Programmers found
”, please try to turn off Stand-Alone
programmer, by menu “
File / Shut down computer
”, turn off the power button on
the back Side of programmer,
wait for 15 secon
programmer again. If the search result is still
refer to troubleshooting documentation.
tarting programm
10. Each programmer site is uses its own
11. To start the hidden applications of control programmer sites, use
“
Programmer / Connect Sites
”.
12. The “
Connecting sites
“ indicator is displayed during connection of sites.
Additional information about site connection progress is displayed for each site in
panel Status on
13. Programmer sites are
of programmer sites from left to right.
14. When connection process of programmer sites is complete, indicator
“
Connecting Sites
” will be hidden. Panel Status will contain information about
each site.
Loading project file
15. When site status after conn
can begin the Load project operation accessib
The project file can be loaded from default directory
[Projects]
or from any other
location, for example from USB key. For more details about Load project, refer to
the chapter “Menu File“ and Load project. When Load project operation is
successfully
done for all Sites, the “
Ready
“ status must be displayed in panel
Status on touch screen for all connected Sites. If there are some Sites with
different status, use troubleshooting documentation to resolve the problem.
tion of predefined device operation
21
