© 2014 Elo Touch Solutions, Inc. All rights reserved.
User Manual
– 1929LM
SW200158 Rev A - Page 26 of 31
iv) Plug the digital device into a different AC outlet so the digital device and the receiver are on
different branch circuits.
v) Disconnect and remove any I/O cables that the digital device does not use.(Un-terminated
I/O cables are a potential source of high RF emission levels.)
vi) Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter plugs.
(Removing or cutting the line cord ground may increase RF emission levels and may also present a
lethal shock hazard to the user.)
If you need additional help, consult your dealer, manufacturer, or an experienced radio or
television technician.
III. Agency Certifications
The following certifications and marks have been issued or declared for this monitor:
CE marking to low voltage directive and EMC directive
US "NRTL" mark (e.g. UL)
Canadian “NTRL” mark (e.g. CSA) and ICES EMC labeling
US FCC, EMC compliance label
China CCC safety mark and China RoHS marking
Australia/NZ RCM mark
WEEE marking
Korea KC mark EMC
Russia EAC mark
Taiwan BSMI mark
Japan VCCI mark
