UM600609 Rev A page 86 of 94
User Manual
–
Elo Mobile Computer M60/M60C
Section 6: Regulatory Information
Electrical Safety Information
Compliance is required with respect to the voltage, frequency, and current requirements ifndicated on the manufacturer’s
label. Connection to a different power source than those specified herein will likely result in improper operation, damage to
the equipment, or pose a fire hazard if the limitations are not followed.
There are no operator serviceable parts inside this equipment. There are hazardous voltages generated by this equipment
which constitute a safety hazard. Service should be provided only by a qualified service technician.
Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the
equipment to mains power.
Emissions and Immunity Information
Notice to Users in the United States:
FCC
§ 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
§ 15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s
authority to operate the equipment.
§ 15.105
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated to ensure a minimum of 0 cm spacing to any person.
Notice to Users in Canada for IC compliance: This equipment complies with the Class B limits for radio noise emissions from
digital apparatus as established by the Radio Interference Regulations of Industrial Canada.
