Elpress 1664791, User Instructions

PKL54C | USER INSTRUCTIONS

 9

ATTENTION

Keep fingers away from the edges of the cutting 

blades when inserting the moving blade into the 
gear mechanism. The control switch may have 
moved out of neutral mode.

Cutting

1.  Open the moving blade with the control switch.
2. 

Place the cable to be cut against the fixed blade, and close the moving blade around the cable 

by hand, so that the gear rim engages with the tool’s drive mechanism.

3.  Press the control switch in the forward direction (to the left) to cut the cable. Keep the control 

switch pushed in until the cable is completely cut.

4.  To cut several smaller cables in succession, the forward and back setting of the switch can be 

used alternately so that the gear rim is constantly engaged with the drive mechanism.

5.  Clean any dust and particles stuck in the brush after work.

Maintenance

Daily maintenance should ensure that the tool is kept in good working order.

If the tool is maintained regularly, the tool will function smoothly.

•  After use, look for scratches or dents on the blades. If there are scratches, these can be removed 

using a flat grindstone. Clean, sharp blades provide better and safer performance and put less 

load on the tool.

• 

The plastic casing can be cleaned using a soft flannel. Use lubricant to clean the blades 

if necessary.

•  Keep the handle dry and free from grease.
•  Do not allow the tool to fall to the ground or in the bag to avoid damage to internal parts of 

the plastic casing.

•  Store in a cool, dry place. Do not store the tool in places with high temperatures, high humidity 

or direct sunlight.

•  Notify authorised dealers in case of deviations or malfunction of the product.
•  The blades are replaceable wear parts. Replace the blades with new ones if they are damaged 

or worn.

Note: 

Always remove the battery before replacing parts or servicing.