9
CS2500 | INSTRUCTIONS FOR USE
7. Display Menu
When the system is made ready for use, display will show “Date and time” and “Pump-No”
The four switches on the keypad are used for navigation in the control system.
“Main menu”
is reached by pushing the “OK” switch. Up and down switches moves
the cursor to desired line, then the switch marked “OK” must be pressed. Return to main menu
by pressing the “esc” switch. In the main menu it is easy to get information about pump status.
- Log info
Show used part of computer memory
- Reset counter
Reset counter of crimps shown in display
- Clear logs
Clear out memory from all crimplogs
- Settings
Show set values
- Active faults
Show and clear out of error messages
- Admin
Time set log in
- Version info
Information about software
After a complete crimp cycle, information about relevant parameters is shown in display. By using
the down switch on the keypad thid information is easy reached.
If any of the parameters above, press time, pressure, current, voltage, oil temp or motor temp is
out of preset limits there will be an error message with information about the actual problem.
When a crimp cycle has been started but not completed within 60 sec, a message “Time out” will
be shown in the display. All faulty messages can be cleared in
”Active faults”
menu.
Press time
Crimp time, when pressure p is over
15 bar
Max pressure
Max hydraulic pressure reached
during crimp cycle
Max current
Max motor current reached during
crimp cycle
Min battery
Min voltage, battery or net power,
during crimp cycle
Crimp complete
Crimp cycle has been fulfilled, max
pressure reached
Log ID
Crimp identity saved with crimp
characteristic
Cycle counter
Counts every crimp (p > 15 bar),
possible to reset
Total counter
A not resetable total press
counter
Oil temp
Max hydraulic oil temperature during
crimp cycle
Motor temp
Max DC motor temperature during
crimp cycle
