PS710 | INSTRUCTIONS FOR USE
3
IMPORTANT! read this section before using the
PS710!
1. Personal safety
Personal injury risk
- This equipment may only be used by persons with sufficient knowledge
about it’s application and function.
- Before the Product is used this Instruction for use must be studied care-
fully and all instructions must be followed.
- The use of other hydraulic tools than from Elpress may bring about con-
siderable risks for personal injury.
PS710 is an electro hydraulic pump exclusively designed for the use of Elpress hydraulic tools.
The mains cable may only be connected to a 100-240 VAC outlet with protective earth (PE).
This Instruction for use shall always be kept with the PS710.
- The PS710 creates a very high working oil pressure (up to 700 bar or 10 000 psi) in
the pump, hose and tool. To minimize the risk when handling, always use
protective glasses and gloves.
- Do not try to disconnect tool in pressurised state.
- The control handle has to be connected to the tool.
Always check the PS710 before use, with special regards to damage on the hose, control cable,
attached tool and mains cable. If damage is seen or suspected, the unit must not be used and
immediate service actions must be taken.
Note that only authorised service units with access to technical documentation may service the
PS710. Always use spare parts supplied from Elpress.
Note that the hose for this unit may look much like any hydraulic hose, but carries about three
times the pressure of conventional hydraulic hoses. It is therefore absolutely necessary to use only
hoses and fittings designed for these high pressures.
Reduce the safety risks and prolong the service time for the PS710 by handling it with care and by
keeping it clean.
Do not work with attached tools directed towards any one.
Observe the movements of the attached tool to avoid finger damages.
An attached tool is quickly “freezed” by releasing the start switch on the control handle.
The stop switch stops and retracts the tool movement. This function is checked at each
starting up sequence.
At longer stops, switch off the unit and disconnect the mains cord plug.
The
PS710
must not be used for work in explosive environments.
