User manual & technical documentation– Satellites Decentral – NL-GB-DE-FR-ES-RUS-CZ – Rev 1.1 - 28062017
23
Instruction table
B
lo
ck
sat
R
F
B
lo
ck
sat
R
FD
Closed
•
If no cleaning activities are being performed, all valves at the delivery point
should be closed.
•
If no cleaning activities are being performed the handle most be in stop
position (grey).
[1]
√ √
Rinsing
•
Connect the rinse Lance (blue) to the spray gun.
•
Set the handle in the rinse position (blue).
[2]
•
Start rinsing activities.
•
Always close the valves by setting handle in stop position (grey)
[1]
√ √
Foaming
•
Connect the foam lance (white) to the spray gun.
•
Set the handle in the foaming position (white).
[3]
•
Start foaming activities.
•
Always close the valves by setting the handle in stop position (grey)
[1]
•
At first use the foam quality needs to be set. To adjust the setting look at
chapter: Changing settings
√ √
Disinfecting
•
Connect the disinfection lance (red) to the spray gun.
•
Set the handle in the disinfecting position (red).
[4]
•
Start disinfecting activities.
•
Always close the valves by setting the handle in stop position (grey)
[1]
√
After use
•
After each use, each injector must be rinsed through with clean water. For this
purpose, immerse the chemical suction hose into a basin of clean water and,
using the rince lance, operate the spray gun for a minimum of 2 minutes so
that the water rinses the injector, thereby avoiding the formation of crystals in
the injector/suction line.
•
Always close the valves by setting the handle in stop position (grey)
[1]
√ √
