User manual & technical documentation– Satellites Decentral – NL-GB-DE-FR-ES-RUS-CZ – Rev 1.1 - 28062017
26
Installation requirements
Locating
•
Remove the packaging material and
any protective film.
•
Check that the installation is not
damaged. If you find any damage,
contact your supplier immediately
and do not use the installation.
•
Check whether a non-return device is
installed in the water supply as
prescribed by local legislation.
•
Check the screw thread and seal
rings before installation to ensure a
good seal.
Before the installation is
commissioned, the supply
network must be carefully cleaned with
fresh water. The supply network must be
flushed for a good 30 minutes at a flow
rate of 25 litres per minute and a
minimum pressure of 3 bar. This applies
to the supply lines to the satellite.
Always place valves before the
satellite inlet to make sure it
can be disconnected from the water and
air supply.
Never mix chemicals with
eachother as this may present
a hazard to the surrounding area and/or
the installation. When working with
chemicals, always use personal
protective equipment as prescribed by
local legislation. Chemicals that can react
with each other must never be used.
Connecting
•
Remove the packaging material and
any protective film.
•
To demount wall bracket, unscrew
screw
[A]
to remove cover
[B]
.
Unscrew screws
[C]
and
[D]
to
disconnect the wall bracket from the
satellite.
•
Mount the wall bracket against a flat
wall by transferring the holes drilled
in the wall bracket onto the wall. The
installation height is approx. 1400
mm from floor level to the underside
of the satellite (see lay out).
•
Reassemble parts
[A]
,
[B]
,
[D]
and
[D]
in reverse order.
A
B
C
D
C
D
