5
KL85 | INSTRUCTIONS FOR USE
Safety instructions relative to the working area:
Keep order in your working area. Disorder in the working area increases the risk of an accident.
Take account of the working area environment. Do not expose electrical tools to rain. Do not use
electrical tools in a moist or damp environment. Ensure that the working area is well-lit. Do not
use electrical tools if flammable liquids or gases are nearby.
4. SPECIFIC SAFETY INSTRUCTIONS
At all work, observe the movement of the blades to avoid finger dangeres.
Hydraulic cutting tool:
Do not put your fingers between blades! Risk of grave cuts. Handle the lock
-
ing spindle with precaution to avoid being pinched.
The cutting head must not be used for work under tension or in explosive environments. Do not
use this tool on live cables.
5. INSTRUCTION FOR USE
Do not use this tool on live cables.
Put away the plugs of the cutter head and the
hose, and connect the hose to the hydraulic
head.
Before using the cutter, check that the moveable
blade is in its rest position (fully retracted, by
actuating the release trigger, see instructions for
the Elpress pump (red switch).
Slide the cable through the tool head, or open the
head by removing the lock drift. Check that the
lock is well closed at the beginning of working.
Actuate the pump to move forward the blade onto
the cable (white switch,see instructions for the pump).
Check that the cable is in the correct cutting position.
Then operate the pump, so the blade moves regularly untill
the cutting of cable is completed.
(See instructions for the pump booklet).
After use, wipe the tool carefully and replace it in its case.
