8
ELPRESS MINI | INSTRUCTION FOR USE
Charge at 5 – 40 °C.
If the battery has been used or it has been in the sun so that it is hot (>65°C)
the right LED can start to flash red. Take out the battery from the charger
and let it cool down. Charging can not be performed under 5 °C.
Do not leave or operate the charger in rain or snow and do not charge in
explosive environments.
No other types of batteries can be used in the MINI-tools.
4.3 The light diode display
This tool is equipped with a special circuit board incorporating
several important features to inform the user about the current
status of the unit. The LED (Pos.-No. 7) signals in the following
cases:
5 Trouble shooting
A.
The tool leaks oil
; return the tool to Elpress service. Do not open
the tool - no action can be done without special equipment and
competence.
B.
The tool does not reach the required working force;
stop
the crimping process. Press the reset button (2) and trigger
simultaneously (button 1) for about 10 seconds. If the malfunction
still exists, return the tool to Elpress service.
1
2 x
20 sec
2
20 sec
3
20 sec
4
3 x
5
3 x
6
When: After inserting the battery
Why: Self check
When: After working cycle
Why: Low battery level
When: After working cycle
Why: Time for service
When: After working cycle
Why: Tool or battery too hot
When: After interruption
Why: Error: Manual interruption of the
crimp
When:After working cycle
Why: Error: Automatic opening of the tool
due to exceeding the
crimp force
