Chapter 4
Configuration
MAN_905G_1.16
Page 44
Loading configuration from an existing module
To load the configuration from a module, connect the module to the PC via the RS232 cable,
put the module into “Configuration Mode” by pressing the configuration button on the top
end-plate, and click on “Load Unit”. This will allow you to view the module configuration,
change it, or copy it for another module - refer to section 4.10 for full details.
Adding a new module to the system configuration
To add a new module to the system configuration, click
on “Units” on the left-hand menu and then “Add Unit”.
Select the type of module from the list. For 905G
modules, you will be asked to select the bus protocol.
This must match the 905U-G module type you have
installed.
You have the option of selecting a unit address for the
module, or allowing the program to select one
automatically. If you choose to select the unit address
the program will display the list of available addresses
for you to select - valid addresses are 1 – 95.
The default name for a unit will include the unit
address. For example, “905-G#10” is a 905U-G
module with unit address 10. You can change the name
of a unit - for example, you could replace the default
name with “Pump Station 14”.
