Page 12/20
CA-6001Bh
12.2007AG
Operating Manual EHT1
Datalogger HAMSTER-E EHT1
2.1 Display
After reprogramming the datalogger, all LCD segments are switched
on as a display test.
After the display test the actual date and time of the datalogger are
displayed for approximately 4 seconds.
Afterwards the estimated, remaining battery capacity (values 0 to
100%) is displayed for approximately 2 seconds.
If the display is switched on actual measurement values of both
sensors are displayed. The symbol LOG indicates that data logging
is in progress – if it blinks, the data memory is filled up to more
than 90%. The MIN / MAX values indicate the recorded extreme
values.
If the display is switched off LOG is displayed only. The datalogger
is in the power safe mode. Measurement values are taken in the
logging interval only and the battery consumption is minimal.
Blanc Display
See Chapter 2.2