Page 14/20
CA-6001Bh
12.2007AG
Operating Manual EHT1
Datalogger HAMSTER-E EHT1
Warning: date / time display: after a battery voltage drop, e.g. battery
exchange, all 4 arrows show up in the display. However all
datalogger functions are working without any limitations. Check date
and time and if necessary set them by the elproLOG software.
If a blinking BAT is displayed (for 1 second in a 10 seconds interval),
the end of the estimated battery life is near. Replace the battery as
soon as possible!
If BAT is displayed permanently, the battery voltage is too low and
the datalogger may not be started. If the datalogger is running, the
recording will stop. Communication with
the computer may
temporarily work. Replace battery as soon as possible!
2.2 External start with the Start/Stop Magnet
•
This function has to be enabled by the PC in advance.
•
Start logging with the Start/Stop Magnet
Put the Start/Stop Magnet (not included in delivery) in the optical slot, after
approximately 1 second a decimal point will show up in the display. Remove the
Start/Stop Magnet immediately (as long as the decimal point is visible). The
datalogger has started.
If the datalogger is in
the Start/Stopp mode
and is waiting for the
start, the display is
blanc!