CA-6001Bh
Page
15/20
Operating Manual EHT1
12.2007AG
Datalogger HAMSTER-E EHT1
2.3 Manual reset of MIN – MAX values
Put the Start/Stop Magnet (not included in delivery) in the optical slot, after
approximately 1 second a decimal point will show up in the display. Remove the
Start/Stop Magnet immediately (as long as the decimal point is visible). The old MIN
– MAX values will deleted.
This function is available after initialization date: nxx.xx.2006
This data is documented in line: "Initialized on: …." In the datalogger status report.
2.4 Password
All settings in the datalogger HAMSTER-E are password protect able. You are going
to find this function in the menu item: Extended Setup.. / Set new password.. The
password may be up to 8 characters long.
•
Assigning a new password e.g. elpro
If the datalogger is protected by a password already, enter
this particular password as “Old Password”.
•
Removing the password e.g. elpro
Change Password
OK
Old Password:
Cancel
X
Confirm New Password:
New Password:
elpro
elpro
Change Password
OK
Old Password:
Cancel
X
Confirm New Password:
New Password:
elpro
ATTENTION
For technical circumstances do not use capital or special characters
in the password please!