1000475V01E DOC_Operation Manual LIBERO Cx BLE.docx | Page 27 / 34
The execution of each action must be confirmed immediately after the selection in order to exclude
unintentional operating errors.
Starting a logger
is done by tapping "Start" in the control panel.
On the display of the logger
you will see a flashing “Run”
symbol confirming that the logger has started logging.
Stopping a logger
is done by tapping "Stop" in the control panel.
On the display of the logger you will see "Make PdF"
confirming that the logger has stopped logging and that it is
now possible to download the PDF report.
Alarm monitoring
is
activated
by tapping "Alarm On" in the control panel.
The logger display will show the alarm bell icon with the "ON"
status message above it.
Alarm monitoring
is
deactivated
by tapping "Alarm Off".
On the logger display the status message under
the alarm bell icon changes to "OFF".
At the same time the measured temperature
value and the note for reactivating the alarm
monitoring "AL on" are displayed underneath in
alternating cycles.
A
PDF report
is generated and downloaded to the smart device by tapping
«PDF Export».
After this action has been executed the logger will
display "Stop" if the logger was stopped before
the download command was issued.
If a download is requested during operation ("Run
Mode") the logger continues to run without any
change in recording mode.
