24 - EN
ECOLOG-NET LP4
EL6006Ee
Status and error messages
10. Status and error messages
10.1 Datalogger display and elproLOG ANALYZE
10.2 Datalogger status in elproLOG ANALYZE
RAM IMG-BMP
destroyed
This error message appears in the datalogger status report in line: "Module time". The cause of this error
message may be a battery change if the battery change time was not programmed (
nance
).
System resets since
last reprogram-
ming.
This message is shown in the data logger status in line: "Last reprogrammed on". It is the result of the data
logger reset counter. All entries in the alarm protocol will be erased!
Battery
The status of the batteries is displayed in the (elproLOG ANALYZE) status information.
Battery replacement:
Firmware
The version of the firmware is documented in the status.
Display
elproLOG ANALYZE
CAL
--
Additional alarm text in the power saving mode
Strt
--
Datalogger is waiting for the log start time programmed at menu item:
Datalogger setup
StOP
--
Datalogger is in Start/Stop mode and the memory is full. No further
measured values can be logged. In order to resume data logging, the
logger must be reprogrammed. This is the condition upon delivery of
ECOLOG-NET LP4.
b.F.
Battery voltage is low
C.F.
C.F.
Faulty datalogger
HHHH
--
Logger keyboard is defective
L.C.
Faulty datalogger
O.F.
>=max
- Measured value is larger than the allowed maximum
- Sensor - cable damage
U.F.
<=min
- Measured value is smaller than the allowed minimum
- Sensor - short-circuit
