2.1 Pedestrian Access Travel Time
This sets the time the gate opens when a Pedestrian Access input is activated.
2.2 Pedestrian Access Auto Close Time
This sets the countdown timer for automatically closing the gate when a Pedestrian Access input is
activated.
2.3 Pedestrian Access Auto Close Time with PE Trigger
This Auto Close starts counting down as soon as the Photoelectric Beam has been cleared after a trigger,
when the gate is in the Pedestrian Access position. If there is no Photoelectric Beam trigger the gate will
remain in Pedestrian Access position.
2.4 Pedestrian Access Auto Close on Sequential Obstructions
If the Pedestrian Access Auto Close is set and the gate closes onto an object the gate will stop and
reopen. This setting sets the amount of times the gate will try to Auto Close. After trying for the set limit
the gate will remain open.
2.5 Pedestrian Access with Hold Gate
If the Pedestrian Access hold gate is ON and the Pedestrian Access input is permanently activated the
gate will remain open in the Pedestrian Access position. Open input, Close input, Push Button input and
remote controls are disable. Used in Fire Exit applications.
Menu 3 – Input Functions
This allows you to change the Polarity of Photoelectric Beam, stop and limit switch inputs.
Menu No.
Input Functions
Factory Default
Adjustable
3.1
Photoelectric Beam Polarity
Normally Closed
Normally Closed /
Normally Open
3.2
Limit Switch Polarity
Normally Closed
Normally Closed /
Normally Open
3.3
Stop Input Polarity
Normally Open
Normally Open /
Normally Closed
3.4*
Auxiliary Input (M2 Open Limit Terminal)
Disabled
Disable /
Safety Bump Strip
3.5
Exit
14
Double Gate & Door Controller
with Eclipse
®
Operating System (EOS)
* 3.4: This option is only available when used for single gate mode
Motor 2 Open Limit terminal can be used to wire Elsema’s safety bump strip on a single gate application. Its
functions are the same as it’s set in menu 12.7.
