ELSEMA
1, 2, 4, 8-Channel 151MHz Transmitter - FMT15101E, FMT15102E, FMT15104E, FMT15108E
Installation Instructions for FMT15101(E) & FMT15102(E)
Off Delay 2 – 62 seconds
Transmitter will transmit a 1.5 second transmission burst and then stop for the "off delay" time
selected. The "off delay" time is user selectable between 2 to 62 seconds by adjusting trimpot on
the transmitter board. If the inputs change during the "off delay" period the new code will be
transmitted immediately. When the "off delay" time lapses, transmitter will transmit another
burst. The transmitter will cycle (transmission and off delay) indefinitely, if at least one input is
ON and supply is connected.
Off Delay 1 – 10 minutes
Same as mode 1 except the "off delay" is user selectable between 1 to 10 minutes.
Continuous Transmission*
Transmitter will transmit continuously, if at least one input is activated and supply is connected.A
transmission limit of five minutes is used to comply with local radio regulations.
To activate a receiver longer than 5 minutes, use a delay off feature in the receiver (FMR15101) and
transmitter. The delay off feature in the receiver needs to be set more than the transmitter. This
ensures that the transmitter keeps resetting the off delay in the receiver.
1.5 – 10 seconds one burst transmission
Transmitter will transmit one burst and then go to standby or sleep mode. Adjusting the trimpot will
vary the burst length. When the input is changed and supply is connected, transmitter will transmit
one new burst of the new code.
Sleep mode (10 uA) is activated when all inputs are OFF; this applies to all four modes
(Grey illustrates the position of the DIP switches)
•
Refer to the website for further details.
http://www.elsema.com/contitran.htm
The
transmitter mode for FMT15104 is
user selectable by simply setting the
1-Way dip-switch
on the
transmitter board.
Transmitter Modes
(FMT15104)
Off Delay 2 – 62 seconds
Transmitter will transmit a 1.5 second transmission burst and then stop for the "off delay" time
selected. The "off delay" time is user selectable between 2 to 62 seconds by adjusting trimpot on
the transmitter board. If the inputs change during the "off delay" period the new code will be
transmitted immediately. When the "off delay" time lapses, transmitter will transmit another
burst. The transmitter will cycle (transmission and off delay) indefinitely, if at least one input is
ON and supply is connected.
Continuous Transmission
Transmitter will transmit continuously, if at least one code switch from the 12-Way code switch is
ON and supply is connected. A transmission
limit of five minutes
is used to comply with local radio
regulations.
To activate a receiver longer than 5 minutes, use a delay off feature in the receiver (FMR15101) and
transmitter. The delay off feature in the receiver needs to be set more than the transmitter. This
ensures that the transmitter keeps resetting the off delay in the receiver.
Transmitter mode for
FMT15108
is 5 min
Continuous transmission
only.
ON