ELSEMA
4G Receiver with relay output, G-2025
Page
3
www.elsema.com
Setup and Programming Instructions
1.
Caller ID must be enabled on all
authorized
users phone so that the GSM Receiver knows who's calling.
2.
Open the back cover of the GSM receiver and insert the SIM card.
3.
Connect the power supply and switch the GSM Receiver ON. The ON switch is located near the SIM
card holder
4.
Connect The GSM receiver to the computer using the USB cable included.
5.
On desktop, right click "My computer" >>> "Property" >>> "Hardware" >> "Device Manager".
6.
Find "Ports (COM & LPT)", check the port number of "Silicon Labs CP210xUSB to UART Bridge", for
example: COM3.
7.
If this driver is not visible, install the driver from the USB flash drive included.
8.
Run the configuration software, type in the COM Port number, for example:COM3 (without a space).
Click "Open”, if the "COM Port" status at the bottom turns “Green”, connection is successful.
9.
Enter the password and Click "Log in",
default password is 1234
. Enter the new password if you had
previously changed it.
10.
Set the time & date by entering the sim cards number, this must be done first.
11.
Click "Read Settings". Configure the parameters as per your application.
12.
Click "Save Settings"
13.
After finishing the configurations, disconnect the USB cable, restart the GSM receiver by
switching the slide switch near the SIM card to OFF, wait for 5seconds and switch it back to ON.
