ELSEMA
4G Receiver with relay output, G-2025
Page
9
www.elsema.com
Delete a user
o
PwdAserial number##
E.g A user on position 13 (serial number 13) has to be deleted from the user list, the following SMS
command is needed:
1234A013##
It is recommended to keep a list of all users and their numbers position.
If a new number is programmed on a location which already has a number stored, the old number will be deleted
and the new number is stored.
Allow access to all numbers calling the GSM receiver
o
PwdALL#
To allow access to anyone making a call to the GSM receiver, the following SMS command is needed:
Warning! This will allow anyone who makes a call to operate the GSM receiver.
1234ALL#
Allow access only to authorized numbers calling the GSM receiver
o
PwdAUT#
To allow access to authorized numbers only, the following SMS command is needed:
1234AUT#
This allows only the numbers that are authorized to operate the GSM receiver.
*This is set as factory default and is recommended for secure operation.
Setup Relay OFF delay
o
PwdGOTclose time#
The relay OFF delay can be set from 000-999 seconds. The factory default is 0.5 seconds.
000—0.5 second
999— Latching mode. Relay will stay ON until a second call is made.
E.g. If the relay OFF delay needs to be set at 10 seconds, the following command is needed
1234GOT010#
Relay will stay ON for 10sec once activated.
Controlling the relay with SMS messages
o
PwdCC
1234CC
Switches the relay ON (The relay stays ON for the OFF delay time set in the above command)
o
PwdDD
1234DD
Switches the relay OFF
