ELSEMA
MD240-2 Vehicle Loop Detector
- 7 -
Dip switch 6 and 7 of CH2
Function
Frequency Selection
Dip switch 6 and 7 is
OFF
High
Dip switch 6 is ON
Medium-High
Dip switch 7 is ON
Medium-Low
Dip switch 6 and 7 is
ON
Low
Setup Instructions
Power Led
RED power LED indicates “Power ON”
Detecting Led
Continuously On: Indicates vehicle detection.
Blinking slowly: Indicates loop is short circuit or the number of twists after the loop is not enough.
Blinking fast: Indicates loop is open circuit or too many twists after the loop.
Power : Red Led
If it is fully lit, power is supplied.
Green Led
CH1
If it is fully lit, a vehicle is detected on loop 1. If it blinks, then loop 1 is
faulty.
CH2
If it is fully lit, a vehicle is detected on loop 2. If it blinks, then loop 2 is
faulty
