2020/04/07
WCC Lite user manual
Modem init timeout
:
Maximum amount of seconds before the device gives up on finishing
initialization;
Use default gateway
: Uses the default gateway obtained through DHCP. If left unchecked, no default
route is configured;
Prefer PPP connection
: If ,the modem, supports PPP and any other communication protocol (e.g.
QMI, RNDIS and etc.), prioritise PPP type connection;
Use gateway metric
: The WAN configuration by default generates a routing table entry. In this field
you can alter the metric of that entry. Higher metric means higher priority;
Use DNS servers advertised by peer
: Uses DNS servers obtained from DHCP. If left unchecked, the
advertised DNS server addresses are ignored;
LCP echo failure threshold
: LCP (link control protocol) is a part of PPP (PointtoPoint Protocol) and
helps to determine the quality of data transmission. If enough failures happen, LCP presumes link
to be dead. 0 disables failure count checking;
LCP echo interval
: Determines the period of LCP echo requests. Only effective if LCP echo failure
threshold is more than zero;
Inactivity timeout
: Station inactivity limit in seconds: if a station does not send anything, the
connection will be dropped. A value of 0 can be used to persist connection.
Override MTU
: Set custom MTU to gsm interface.
Note: If modem uses QMI connection protocol and user haven’t defined custom
MTU setting, the MTU on interface will be set to operator’s defined MTU value.
GSM configuration ends with firewall settings. A user can assign an already defined firewall zone or
create a new one.
8.7.2
Wireless
The wireless network interface parameters and configuration are described in this section.
75
1.4.0 | ELSETA | Internal web page
