MISSION 1K●2K●3K
SINGLE PHASE
Rev. 02
– 19 March 2015
11
2
When turning off the UPS, it will do self-testing firstly. LED light and go out circularly and orderly until there
is no display on the panel.
4.2.3 UPS self-test/mute test operation.
1
When UPS is in line mode, press and hold the self-test/mute key for more than 1 second, LEDs light and
go out circularly and orderly. UPS comes to self-test mode and tests its status. It will exit automatically after
finishing testing, LED resume.
2
When UPS is in battery mode, press and hold the self-test/mute key for more than 1 second, the buzzer
stops beeping. If you press and hold the self-test/mute key for one more second, it will restart to beep
again.
4.3 Parameter setting
UPS has setting function. It can run the setting on any mode. After setting, it will become effective at once when
meets some standards. The set information can be saved only when the battery connected and normally turning
off the UPS.
The operation of setting is as following:
4.3.1 ECO mode setting
1
Enter the setting interface. Press and hold the function setting key
for more than 2 seconds, then
come to setting interface, the letters “ECO” will flash as following:
2
Enter the ECO setting interface. Press and hold the function setting key
for more than half a second
(less than 2 seconds), then come to setting interface of ECO, at this time, the letters “ECO” will light for a
long time. The “ON”(or OFF) below the ECO will flash. Press and hold the inquiring key
for more than
half a second (less than 2 seconds) to determine whether the ECO function is used or not. If used, the
corresponding word is “ON”, if not, the word is “OFF”. It can be determined by yourself.
3
Confirm the ECO selecting interface. After selecting ON or OFF, press and hold the function setting key
for more than half a second (less than 2 seconds). Now, the ECO setting function is completed and
the “ON” or “OFF” below the “ECO” will light without flash.
4
Exit from the setting interface. Press and hold function setting key
for more than 2 seconds, exit from
he setting interface and turn to main interface.
