NEMO2.0
65 • 80 • 120 • 160 • 200 • 300 • 400
LINE INTERACTIVE
Rev. 02 27 Gennaio 2017
4
3 - INSTALLATION AND OPERATION INSTRUCTIONS
WARNING:
The unit is shipped from the factory with a fully charged internal battery, however, it could be
discharged during transportation, so it has to be recharged before use. To do this, connect the
unit to an appropriate power outlet and let the battery recharge for at least 6 hours without any
load connected.
Install the UPS according to the following items:
Install the UPS in an environment that is free of excessive dust, corrosive gas and conductive
contaminants and where there is adequate air circulation around the unit.
To place the UPS in ideal location that allow you to check visual alarms and sound indicators.
To place the UPS at least 20cm far from any monitor or screen in order to avoid interference.
Connect the power cord to an earthed power outlet.
Connect your computer and its devices to the UPS output outlets.
Don’t connect laser printers to UPS output.
To turn on the UPS press the start button located on the UPS front panel and wait for the test completion
until the beep ends and the blue display lights up. Your UPS is now working.
From now on your computer and its connected devices are protected by the UPS.
Before turning off your UPS, make sure that your computer or any other electronic equipment has been
turned off completely.
To turn off the UPS, press the button on front panel, the blue display will turn off, then your UPS will be
switched off.
IMPORTANT
: The total power consumption of the load must not exceed the maximum power rating of the
UPS, specified on UPS label.
4
– UPS TEST
If you want to simulate a network failure, then proceed by unplugging the UPS power cord from the mains
socket
. Don’t turn off the UPS.
“Batt. Mode” signal will appear on the display and the buzzer will beep every 10 seconds (with fully charged
battery). To resume normal operation with electrical network, simply reconnect the UPS power cord to the
mains socket. After a certain delay (intentional delay in order to protect the load from surges that may occur
when re-connecting the power cord or when the voltage is back after a power outage), the "Batt. Mode " icon
will be off, the buzzer will stop beeping and the" AC Mode "icon will be displayed.
