Weather Station P03/3-RS485 • Version: 11.10.2011 • Subject to technical alterations. Errors excepted.
10
Fig. 8 b
Drill hole plan
Preparing the weather station
Fig. 9
The weather station cover with the rain sensor snaps in on the left and right along the
bottom edge (see Fig. 9). Remove the weather station cover. Proceed carefully, so as not
to pull off the wire connecting the PCB in the bottom part with the rain sensor in the
cover (wire with push-connector).
Push the connection cable through the rubber seal on the bottom of the weather station
and push the power and bus cables onto their designated terminals. The connection is
by typical telephone cable (J-Y(ST)Y 2
×
2
×
0.8).
