4
Installation and commissioning
RF-Router-N
• Version: 10.05.2016 • Technical changes and errors excepted.
2.3. Connection
The radio router is plugged into a mains socket (CEE 7/4). The mains voltage must be
230 V AC / 50 Hz.
Install and use only in dry interior rooms.
Avoid condensation.
Do not expose to continuous sun radiation
to avoid overheating.
The housing is not UV-resistant.
The
Radio Router N
is taught-in for the controller like a radio actuator. In the menu
System > Installation > Radio connection > RF Router > Status
other radio clients that have already been taught-in are assigned to the router. Their
radio signal is then routed through the
RF-Router-N
if the transmission path is too
long for a direct connection.
2.3.1. Radio communication schema
Radio actuators (ventilators, relays, motor control units ...) can only be operated with
the remote control Remo 8
via the controller
. They can
not
be additionally
switched di-
rectly with the remote control.
2.4. Notes on mounting and commissioning
Device must not be exposed to water (rain). This could result in the electronic being
damaged. A relative air humidity of 95% must not be exceeded. Avoid bedewing.
Controller
Remote control
Remo 8
Motor control unit
RF-MSG (motor control unit)
RF router
Ventilation device
WL610
RF relay
Remote control
Remo 8
Radio communica-
tion
directly
with
the Controller:
Radio communica-
tion with the control-
ler
via RF Router
:
This device must also
be taught-in at the
controller.