5
Installation and commissioning
RF-Router-N
• Version: 10.05.2016 • Technical changes and errors excepted.
2.5. Establishing a wireless connection
If in the system there are several radio clients operating on one mains line, it is better
to teach every radio client separately
before
installation.
1.
Put the control unit into teaching mode (observe the corresponding manual/data
sheet).
2.
Plug in the RF router. The device learns a connection to the control unit on its own
3 seconds after the mains voltage is applied. Only one radio client can be recog-
nised at a time.
Observe the response from the control system ("device taught").
The procedure for assigning radio clients to the router is described in the operating
manual for the controller.
