7
Installation and commissioning
Attention! Mains voltage! The legal national regulations
must be complied with.
Installation, inspection, commissioning and troubleshooting of the weather station must
only be carried out by a competent electrician. Disconnect all lines to be assembled, and
take safety precautions against accidental switch-on.
The weather station is exclusively intended for appropriate use. With each inappropriate
change or non-observance of the instructions for use, any warranty or guarantee claim
will be void.
After unpacking the device, check immediately for any mechanical damages. In case of
transport damage, this must immediately notified to the supplier.
If damaged, the weather station must not be put into
operation.
If an operation without risk may supposedly not be guaranteed, the device must be put
out of operation and be secured against accidental operation.
The weather station must only be operated as stationary system, i.e. only in a fitted
state and after completion of all installation and start-up works, and only in the
environment intended for this purpose.
Elsner Elektronik does not assume any liability for changes in standards after
publication of this instruction manual.
Location
Select an assembly location at the building where wind, rain and sun may be collected
by the sensors unobstructedly. Do not assemble any construction components above
the weather station from where water may drop on to the rain sensor after it has
stopped raining or snowing. The weather station may not be shaded by the building or
for example by trees. Leave at least 60 cm of free space beneath the weather station in
order to enable a correct wind measurement and in order to avoid that the weather
station is snowed in if there is heavy snowfall.
Iron constructions or huge metal sheets directly behind or in the vicinity of the weather
station reduce the reception quality of the assembled radio clock receiver. Please take
this into consideration when selecting the assembly location. The reception of the DCF
signal may also be disturbed or made impossible by magnetic fields, emitters and
