4
Weather Station Suntracer KNX sl basic
• Stand: 11.03.2016 • Technische Änderungen und Irrtümer vorbehalten.
1.
Description
The
Weather Station Suntracer KNX sl basic
for the KNX building bus system
measures temperature, wind speed, brightness and recognises precipitation. All valu-
es can be used for the control of limit dependent switching outputs. States can be lin-
ked via AND logic gates and OR logic gates. Multi-function modules change input data
as required by means of calculations, querying a condition, or converting the data
point type.
The compact housing of the
Suntracer KNX sl basic
accommodates the sensors,
evaluation circuits and bus-coupling electronics.
Functions:
•
Brightness measurement
(current light strength) with 3 sensors. Separate
values, maximum or mixed value usable
•
Wind measurement
: The wind strength is measured electronically and thus
noiselessly and reliably, even during hail, snow and sub-zero temperatures.
Even turbulent air and rising winds in the vicinity of the device are recorded
•
Precipitation detection
: The sensor surface is heated, so that only drops and
flakes are recognised as precipitation, but not mist or dew. When the rain or
snow stops, the sensor is soon dry again and the precipitation warning ends
•
Temperature measurement
•
Frost protection for shading systems
•
Switching outputs
for all measured and computed values. Threshold values
can be adjusted per parameter or via communication objects
•
8 AND and 8 OR logic gates
, each with 4 inputs. All switching events as well
as 16 logic inputs (in the form of communications objects) can be used as
inputs for the logic gates. The output of each gate can be configured optionally
as 1-bit or 2 x 8-bit
•
8 multi-function modules
(computers) for changing the input data by
calculations, by querying a condition or by converting the data point type
Configuration is made using the KNX software ETS. The
product file
can be downloa-
ded from the Elsner Elektronik homepage on
www.elsner-elektronik.de
in the “Ser-
vice” menu.
1.0.1. Deliverables
•
Weather station
•
Stainless steel installation band for pole installation
•
4×50 mm stainless steel roundhead screws and 6×30 mm dowels for wall
mounting. Use fixing materials that are suitable for the base!
•
Size 6 Torx bit
