37
Now you are in basic settings. Proceed as described in the basic settings
chapter „1. Radio connection to weather station“ (p. 20).
•
Then check the function of the sensors (see next chapter).
Sensor testing
In case of malfunctions of the sensors, the display shows error messages instead
of values. Please observe the chapter „Error messages“ on this.
Sun sensor testing
By the short pressing of the
key on the operating unit you get to the lightness
display (see chapter "Display of lightness and wind speed"). The upper value
indicates the intensity of lightness in kilolux (kLux).
The sun sensor is located beneath the frosted glass cover of the weather station.
If lightness is not sufficient, you must illuminate the weather station from above
with a powerful torch until a value is indicated.
Wind sensor testing
By the short pressing of the
key on the operating unit you access the wind
speed display (see chapter "Display of lightness and wind speed"). The lower
value indicates the speed in meters per second (m/s). The sensor pipe is on the
front side at the bottom part of the weather station. If you blow in there, the value
in the display changes.
Note: During the first approx. 90 seconds after the return of voltage at the
weather station, the wind value is not displayed correctly (e.g. after a power fail
or in case of a first start).
